Sanyo PLC-XM150L User Manual

-18-
Mechanical disassembly flow chart
1. Lamp cover and Prism cover removal
2. Fan (FN905) and Main board removal
3. A/V board removal
4. Shutter, Net Joint and Sensor C board
removal
6. Projection Lens removal
7. Optical Unit removal
8. Power Box and Thermal SW (SW902)
removal
9. Control board and Fans (FN902, FN903,
FN904) removal
7-1. Lens Shift assy removal
Mechanical disassembly should be made by following procedures chart.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws, and the wiring method of the leads and ferrite cores
should be placed exactly the same position as the original otherwise it may
cause loss of performance and product safety.
Screws Expression
(Type Diameter x Length) mm
T type M Type
Mechanical Disassembly
5. Lamp, Lamp Cover and IC Connect
board removal
8-1. Power Box disassembly and Fan
(FN901) removal
10. Filter Assy removal
11. Fans (FN908, FN909, FN910) removal
12. Fans (FN906, FN907, FN911) and
Speaker removal
1-1. Cabinet top removal

Sanyo PLC-XM150L Specifications

General

Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Analog signal format system	NTSC, PAL, SECAM
S-Video inputs quantity	1
Dimensions (WxDxH)	489.5 x 371.1 x 164 mm
Noise level	38 dB
Power consumption (standby)	0.6 W
Power consumption (typical)	400 W
Power consumption (economy mode)	338 W

Weight and Dimensions

Weight	8900 g