Sanyo PLC-XP57L User Manual

37
Press the POINT LEFT/RIGHT buttons to adjust the gamma value
to obtain better balance of contrast (from 0 to 15).
Gamma
Press the POINT LEFT button to decrease the sharpness of the
image; press the POINT RIGHT button to increase the sharpness of
the image (from 0 to 31).
Sharpness
Press the POINT LEFT button to lighten blue tone; press the
POINT RIGHT button to deepen blue tone (from 0 to 63).
White balance (Blue)
An interlaced video signal can be displayed in progressive. Press
the POINT LEFT/RIGHT buttons to change the progressive scan
mode.
Off . . . . Progressive scan mode is “Off.”
On . . . . Progressive scan mode is “On.”
Film . . . Select for watching a film. With this function, the
projector reproduces pictures faithful to the original film
quality.
Noise interference on the screen can be reduced. Press the POINT
LEFT/RIGHT buttons to change the noise reduction mode.
Off . . . . Noise reduction mode is “Off”
L1 . . . . . For lower reduction
L2 . . . . . For higher reduction
Noise reduction
Progressive
Image Level Menu
Move the red frame pointer to any of
Image 1 to 10 where you want to set
and then press the SELECT button.
Store icon
Press the SELECT button at this
icon to store the adjustment.
PICTURE IMAGE
Press the POINT LEFT button to lighten red tone; press the POINT
RIGHT button to deepen red tone (from 0 to 63).
White balance (Red)
Press the POINT LEFT button to lighten green tone; press the
POINT RIGHT button to deepen green tone (from 0 to 63).
White balance (Green)
Exit the IMAGE ADJUST Menu.
To store the manually preset image, move the red frame pointer to
the Store icon and press the SELECT button. The Image Level
Menu appears. Move the red arrow pointer to any of the Image 1 to
10 in which you want to set and press the SELECT button.
To reset the adjusted parameters, select Reset and press the
SELECT button. A confirmation box appears. Select [Yes]. All the
adjustments return to their previous figures.
Reset
Store
Quit
Press the SELECT button at this icon to
display other items.
Press the SELECT button at this
icon to display the previous items.
Press the POINT LEFT/RIGHT
buttons to adjust the value.
NOTE:
• The Film mode in the Progressive function cannot be selected when the video
signal format is 1080i or 1035i.

Sanyo PLC-XP57L Specifications

General

Number of colors	1.073 billion colors
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Resolution	2359296 pixels
Aspect ratio	4:3
Dimensions (WxDxH)	319 x 429.5 x 168 mm
Power requirements	100-240 V AC, 50/60 Hz
Lamp type	UHP
Lamp power	318 W
Light source type	Lamp
Noise level	36 dB
Dot clock scanning frequency	180 MHz
Analog signal format system	NTSC, NTSC 4.43, PAL, SECAM
Audio (L/R) in	2
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	1
VGA (D-Sub) ports quantity	5
Component video (YPbPr/YCbCr) in	3
Power consumption (standby)	15 W
Power consumption (typical)	480 W

Weight and Dimensions

Weight	7900 g