Sanyo PLC-XR201 - XGA LCD Projector

50
Setting
Power management
TimeleftbeforeLampisoff.
Power management
Forreducingpowerconsumptionaswellasmaintaining
thelamplife,thePowermanagementfunctionturnsoffthe
projectionlampwhentheprojectorisnotoperatedfora
certainperiod.
Selectoneofthefollowingoptions:
Ready...............  Whenthelamphasbeenfullycooled
down,thePOWERindicatorchanges
togreenblinking.Inthiscondition,
theprojectionlampwillbeturnedonif
theinputsignalisreconnectedorany
buttononthetopcontrolorremote
controlispressed.
Shut down.......  Whenthelamphasbeenfullycooled
down,thepowerwillbeturnedoff.
Off....................  Powermanagementfunctionisoff.
Timer................  Iftheinputsignalisinterruptedand
nobuttonispressedformorethan
30seconds,thetimerdisplaywith
No signalappears.Itstartsthe
countdownuntilthelampisturnedoff.
UsethePoint▲▼buttonstosetthe
Timer(1~30min).
Note:
 FactorydefaultisReady: 5 min.
On start
WhenthisfunctionissettoOn,theprojectorwillbe
automaticallyturnedonjustbyconnectingtheACpower
cordtoawalloutlet.
Note:
•WhenStandby modeissettoEco,On startcannotbe
 selected.IfyouwanttosetOn start toOn,Standby
 mode mustbesettoNetwork.
•Besuretoturnofftheprojectorproperly(see“TurningOff
 theProjector”onpage20).Iftheprojectoristurnedoffin
 theincorrectsequence,theOnstartfunctionwillnot
 workproperly.