Sanyo PLC-XR201 - XGA LCD Projector

52
Setting
Remote control
Thisfunctionallowsyoutochangebrightnessofthe
screen.
Lamp control
Remote control
Lamp life control
Lamp control
Selectthelampoperationwhenthetotallightingtimeofa
lampexceedstherecommendedtotalhoursofuse.
Mode 1.............. Thelampcanbeturnedonevenafter
exceedingtherecommendedtotal
hoursofuse.
Mode 2.............. Thelampcanbeturnedonevenafter
 exceedingtherecommendedtotal
 hoursofuse.Buttheprojectorturnsoff
 automaticallyafter3minutes.
Lamp life control
Note:
•Lampmodecannotbechangedforawhileafterturning
ontheprojector.Lampneedssometimetostabilize
afterthepoweristurnedon.Storedlampmodewillbe
activeafterthelampisstabilized.
•IfMode 2hasbeenselectedandtheprojectionlamp
exceedestherecommendedtotalhoursofuse,the
replacementiconwillbedisplayedatthetimeofpower-
on.Thentheprojectorwillturnoffafter3minutes.
 •TheLampreplacementiconwillnotappearwhenthe
DisplayfunctionissettoOff(p.45),duringFreeze
(p.25),or No show(p.26).
Lamp replacement icon
Thisprojectorprovidestwodifferentremotecontrolcodes:
thefactory-setinitialcode(Code 1)andthesecondarycode
(Code 2).Thisswitchingfunctionpreventsremotecontrol
interferencewhenoperatingseveralprojectorsorvideo
equipmentatthesametime.
WhenoperatingtheprojectorinCode 2,boththeprojector
andtheremotecontrolmustbeswitchedtoCode 2.
To change the code for the projector:
SelecteitherCode 1orCode 2inthisSettingMenu.
To change the code for the remote control:
PressandholdboththeMENUandIMAGEbuttons
togetherfor5secondsormore.Afterchangingthecode,
makesuretheremotecontroloperatesproperly.
Note:
•Whendifferentcodesaresetontheprojectorandontheremotecontrol,anyoperationcannotbemade.Inthatcase,
switchthecodeontheremotecontroltofitthecodeontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolforalongperiodoftime,theremotecontrolcodewillbereset.
High.......... BrighterthantheNormalmode.
Normal...... Normalbrightness
Eco............ Lowerbrightnessreducesthelamp
powerconsumptionandextendsthe
lamplife.