Sanyo PLC-XU106 User Manual

42
Chapter 4 Controlling the Projector
Information
This page is to display the basic information of the projector status. Click
Information on the main menu.
Items Description
Input Displays selected input and source.
System Displays selected signal system.
Signal Input signal status (Yes, No)
Screen Displays screen mode.
Lamp status Displays lamp status with an animation. Refer to the table as shown below.
Security
Displays the security (PIN code lock) status (Yes, No)
PJ time(h) Displays the accumulated use time of the projector.
Lamp Corres. Value(h) Displays the use time (Corresponding value) of the lamp.
Filter time(h)
Displays the accumulated use time of the filter.
Click this button to
update the information.
Indication of the lamp status
Icon display/background Status
White-Yellow/Blue
Lamp on (Normal)
White-Yellow/Red
Lamp on (Lamp is being used over a specified use time, replace lamp
immediately)
Gray/Blue
Lamp off (Normal)
Gray/Red
Lamp off (Lamp is being used over a specified use time, replace lamp
immediately)
Red/Blue with X
Lamp failure (Lamp failure, check lamp condition)
Red/Red with X
Lamp failure (Lamp failure and lamp is being used over a specified use
time, replace lamp immediately)

Sanyo PLC-XU106 Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
Focus	Manual
S-Video inputs quantity	1
Dimensions (WxDxH)	335.7 x 93.9 x 257.5 mm
Noise level	37 dB
Power consumption (standby)	0.9 W
Power consumption (typical)	332 W

Weight and Dimensions

Weight	3400 g