Sanyo PLC-XU106 User Manual

39
Choose Video or S-video by pressing the INPUT button on
the top control, or the VIDEO button or the S-VIDEO button
on the remote control.
1
2
Input Menu
Input Source Selection (Video, S-video)
Video Input
Direct Operation
Menu Operation
When video input signal is connected to the
VIDEO jack, select Video.
Video
When video input signal is connected to the S-
VIDEO jack, select S-video.
S-video
3Note:
When the Input Search function is set to
On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.47).
Top Control
INPUT button
Remote Control
VIDEO button
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź
buttons to select Input and
then press the Point
Ź
or
the SELECT button.
Use the Point
Ÿź
buttons to select either Video or
S-video and then press the SELECT button.
S-video button
Video
S-video
Video
Computer 2(RGB)
S-video
Computer 1(RGB) /
(Component) / (Scart)

Sanyo PLC-XU106 Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
Focus	Manual
S-Video inputs quantity	1
Dimensions (WxDxH)	335.7 x 93.9 x 257.5 mm
Noise level	37 dB
Power consumption (standby)	0.9 W
Power consumption (typical)	332 W

Weight and Dimensions

Weight	3400 g