Sanyo PLC-XU106 User Manual

41
Video System Selection
1
AV System Menu (Video or S-video)
AV System Menu (Component)
2
If the projector cannot reproduce proper video image,
select a specific broadcast signal format from among PAL,
SECAM, NTSC, NTSC 4.43, PAL-M, and PAL-N.
PAL/SECAM/NTSC/NTSC4.43/PAL-M/PAL-N
The projector automatically detects an incoming video
signal, and adjusts itself to optimize its performance.
If the projector cannot reproduce proper video image, select
a specific component video signal format from among 480i,
575i, 480p, 575p, 720p, 1035i, and 1080i.
Auto
COMPONENT VIDEO SIGNAL FORMAT
Video or S-video
Component
The projector automatically detects an incoming video
system, and adjusts itself to optimize its performance.
When Video System is PAL-M or PAL-N, select the system
manually.
Auto
3Note:
The AV System Menu cannot be selected when selecting
RGB (Scart).
Press the MENU button to display the On-Screen
Menu. Use the Point Ÿź buttons to select Input and
then press the Point Ź or the SELECT button.
Use the Point
Ÿź buttons to select Video or S-video
or Computer 1(Component) and then press the
SELECT button.
3
Use the Point Ÿź buttons to select System and then
press the Point Ź or the SELECT button. Use the
Point Ÿźbuttons to select the desired system and
then press the SELECT button.
Video Input

Sanyo PLC-XU106 Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
Focus	Manual
S-Video inputs quantity	1
Dimensions (WxDxH)	335.7 x 93.9 x 257.5 mm
Noise level	37 dB
Power consumption (standby)	0.9 W
Power consumption (typical)	332 W

Weight and Dimensions

Weight	3400 g