Sanyo PLC-XU106

29
Choose Computer 1(RGB) by pressing the INPUT button on the top control or press the COMPUTER 1 button
on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB)
Computer Input
COMPUTER 1 button
3Note:
When the Input Search function is set to
On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.47).
Computer
1
Top Control
Remote Control
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
0HQX8VHWKH3RLQWŸ
ź buttons to select Input and
then press the Point
Ź
or the SELECT button.
8VHWKH3RLQWŸ
ź buttons to select Computer 1.
When Computer 1 is selected, press the Point
Ź
to
access the submenu items8VHWKH3RLQWŸ
ź buttons
to select the RGB input source and then press the
SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Video
Computer 2(RGB)
S-video
Auto
Ato
INPUT button
Computer 1(RGB) /
(Component) / (Scart)