Sanyo PLC-XU106 User Manual

44
Chapter 5 Appendix
Examples of connection
Peer-To-Peer connection
Connecting the projector (PJ01) to the control computer (PC05) directly.
Projector Name: PJ01
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
Computer Name: PC10
IP Address : 192.168.0.10
Subnet Mask : 255.255.255.0
Default Gateway :
DNS :
Computer Name: PC05
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default Gateway :
DNS :
Hub
Projector Name: PJ01
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
Computer Name: PC05
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default Gateway :
DNS :
* UTP cross cable
Connecting the projector (PJ01) to the control computer (PC05) via the hub.
 When the projector is connected to the computer directly without hub, the UTP cross cable
should be used.
To another network

Sanyo PLC-XU106 Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
Focus	Manual
S-Video inputs quantity	1
Dimensions (WxDxH)	335.7 x 93.9 x 257.5 mm
Noise level	37 dB
Power consumption (standby)	0.9 W
Power consumption (typical)	332 W

Weight and Dimensions

Weight	3400 g