Sanyo PLC XU115 - XGA LCD Projector

18
Installation
Connecting the AC Power Cord
This projector uses nominal input voltages of 100-120 V
or 200–240 VAC and it automatically selects the correct
inputvoltage.Itisdesignedtoworkwithsingle-phasepower
systems having a grounded neutral conductor. To reduce
theriskofelectricalshock,donotplugintoanyothertypeof
powersystem.
If you are not sure of the type of power being supplied,
consultyourauthorizeddealerorservicestation.
Connect the projector with all peripheral equipment before
turningtheprojectoron.
CAUTION
TheAC outlet must be near this equipment and must be
easilyaccessible.
Notes:
Unplug theAC power cord when the projector is not in
use.Whenthisprojectorisconnectedtoanoutletwiththe
AC power cord, it is in Stand-by mode and consumes a
littleelectricpower.
TotheACoutlet.
(200 - 240 V AC)
NOTE ON THE POWER CORD
ACpowercordmustmeetrequirementofthecountrywhereyouusetheprojector.
ConfirmtheACplugtypewiththechartbelowandproperACpowercordmustbeused.
IfsuppliedACpowercorddoesnotmatchyourACoutlet,contactyoursalesdealer.
Topowercord
connectoronyour
projector.
Projector side
AC outlet side
Ground
TotheACoutlet.
(120 V AC)
For the U.S.A. and Canada
TotheACoutlet.
(200 - 240 V AC)
For the U.K.
For Continental Europe
ConnecttheACpowercord(supplied)to
theprojector.