Sanyo PLC XU115 - XGA LCD Projector

57
Setting
Factory default
This function returns all setting values except for the user
logo,PINcodelock,LogoPINcodelock,lampcounter,and
filtercountertothefactorydefaultsettings.
ExittheSettingMenu.
Quit
SelectFactorydefaultandthis
boxappears.Select[Yes],and
thenextboxappears.
Select[Yes]to
activateit.
Factory default
Thisfunctionisusedtosetafrequencyforthefilter
cleaning.
When the projector reached a specified time between
cleanings, a Filter warning icon appears on the screen,
notifyingthe cleaningisnecessary.After cleaningthe filter,
be sure to select RESET and set the timer. The Filter
warningiconwillnotturnoffuntilthefiltercounterisreset.
Fordetailsaboutresettingthetimer,referto“Resettingthe
FilterCounter”onpage59.
Filter counter
Filter counter
UsethePoint◄►buttons
to set the timer. Select
from (Off/100H/ 200H/
300H) depending on the
useenvironment.
Filterwarningiconappearsonthescreenataset
time.
Fig.3Filterwarningicon
Fig.4Filterwarningicon
Note:
 •Thisiconalsoappearsatturningon.
Notes:
 •Atselectinginputsource,theicon(Fig.4)
willappear.
 •The Filter warning icons (Fig.3 and
Fig.4) will not appear when the Display
function is set to “Off” (p.48), during
“Freeze”(p.28),or"Noshow"(p.29).
On1
On1