Sanyo PLC XU115 - XGA LCD Projector

29
Basic Operation
blackoutthecapturedimagenormal
• • • • •
PresstheNOSHOWbuttonontheremotecontroltoblackout
the image. To restore to normal, press the NO SHOW button
again or press any other button. When a projected image is
captured and set as “User” in the Logo selection (p.49), the
screenchangeseachtimeyoupresstheNOSHOWbuttonas
follows.
NO SHOW button
PresstheP-TIMERbuttonontheremotecontrol.TheP-Timer
display “00:00” appears on the screen and the countdown
starts(00:00–59:59).
To stop the countdown, press the P-TIMER button. To cancel
theP-Timerfunction,presstheP-TIMERbuttonagain.
P-TIMER button
Press the IMAGE button on the remote control to select a
desired image mode of the screen. See pages 36, 43 for
details.
IMAGE button
“Noshow”disappearsafter4seconds.
P-Timerdisplay
Note:
•Seethepreviouspageforthedescriptionof
otherbuttons.
IMAGE button
NO SHOW button
P-TIMER button