Sanyo PLC XU115 - XGA LCD Projector

26
Basic Operation
RotatetheZoomLevertozoominandout.
RotatetheFocusRingtoadjustthefocusoftheimage.
Zoom and Focus Adjustment
ZoomLever
FocusRing
If a projected picture still has keystone distortion after
pressingtheAUTOSETUP/CANCELbuttononthetopcontrol
or theAUTO SET/CANCEL button on the remote control,
correcttheimagemanuallyasfollows:
Press the KEYSTONE button on the remote control. The
Keystone dialog box appears. Usethe Point ▲▼ buttons to
correctkeystonedistortion.Thekeystoneadjustmentcanbe
stored(p.48).
Reducetheupperwidth
withthePoint
▲button.
Reducethelowerwidth
withthePoint
▼button.
•Thewhitearrowsindicatethatthereisnocorrection.
•Aredarrowindicatesthedirectionofcorrection.
•Anarrowdisappearsatthemaximumcorrection.
•If you press the KEYSTONE button on the remote
control once more while the keystone dialog box is
being displayed, the keystone adjustment will be
canceled.
•The adjustable range is limited depending on the
inputsignal.
Keystone Correction
Top Control
AUTO SETUP/CANCEL
button
POINT▲▼buttons
Remote Control
Auto setup function is provided to automatically correct
Keystonedistortionaccordingtotheprojector’stiltandadjust
thecomputerdisplayparameters(Finesync,Total dots, and
Pictureposition)byjustpressingtheAUTOSETUP/CANCEL
button on the top controlor theAUTO SET/CANCELbutton
on the remote control. The operational setup for the Auto
setupcanbechangedintheSettingmenu.Refertopage47
forthesettingoftheAutosetupfunction.
Notes:
 •AutoKeystonecorrectsverticaldistortiononly;itdoesnot
correcthorizontaldistortion.
 •AutoKeystonecannotworkwhenCeilingfeatureissetto
“On”intheSettingmenu(p.51).
 •Perfect correction of the image distortion cannot be
ensured with the Auto setup function. If the distortion
cannot be corrected properly by pressing the AUTO
SETUP/CANCEL orAUTO SET/CANCEL button, adjust
manuallyby pressingthe KEYSTONEbuttonon
the top
control or on theremotecontrolorselectingKeystonein
theSettingmenu(p.48).
 •Fine sync,Total dots, Horizontal and Vertical position of
some computers cannot be fully adjusted with theAuto
PCAdjustmentfunction.Whentheimageisnotprovided
properly with this operation, manual adjustments are
required(pp.34–35).
AUTO SET/CANCEL
button
Auto Setup Function
POINT▲▼buttons
KEYSTONE button