Sanyo PLC XU115 - XGA LCD Projector

52
Setting
Power management
TimeleftbeforeLampisoff.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projectionlampwhentheprojectorisnotoperatedforacertain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with “No signal”
appears. It starts the countdown until the lamp is turned off.
UsethePoint◄►buttonstosetthecountdowntimer.
Selectoneofthefollowingoptions:
Ready .................. Whenthelamphasbeenfullycooleddown,
the POWER indicator changes to green
blinking. In this condition, the projection
lamp will be turned on if the input signal
is reconnected or any button on the top
controlorremotecontrolispressed.
Shutdown............ Whenthelamphasbeenfullycooleddown,
thepowerwillbeturnedoff.
Off ........................ Powermanagementfunctionisoff.
Standby mode
This function is available when operating the projector via
network.
 Normal ....... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
 Eco ............ Select “Eco” when you do not use the projector
vianetwork.Theprojector’snetworkfunctionwill
stopwhenturningofftheprojector.
Refertotheowner’smanual“NetworkSet-upandOperation”.
Note:
 •WhenselectingNormal,thecoolingfansmayberunning
dependingonthetemperatureinsidetheprojectorevenif
theprojectoristurnedoff.
Pressthe SELECTbuttonat
Powermanagementandthis
dialog box appears. Use the
Point
◄► buttons to choose
one of the three options.
Press the Point
▼ button to
select the timer, and then
usethePoint
◄►buttonsto
settimer.
Note:
 •Factorydefaultis"Ready:5min.".