22
Menu Bar
For detailed functions of each menu, see “Menu Tree” on pages 68-69.
Main Menu
Sub-Menu
Image select
For both of computer and
Video
sources, used to select an image mode from among Dynamic, Standard, Real, Cinema,
Blackboard(Green), Colorboard and Image 1 - 4 (pp.33, 41).
Image adjust
For computer source, used to adjust computer image [Contrast, Brightness, Color temp., White balance (R/G/B),
Sharpness and Gamma] (pp.34-35).
For Video source, used to adjust picture image [Contrast, Brightness, Color, Tint, Color temp., White balance (R/G/B),
Sharpness, Gamma, Noise reduction and Progressive] (pp.42-43).
PC adjust
Select Auto PC adj., Fine sync, Total dots, Horizontal, Vertical, Current mode, Clamp, Display area H, Display area V,
Reset, Mode free and Store to adjust the parameters to match with the PC input signal format (pp.30-32).
Screen
For computer source, used to adjust size of the image [ Normal, Full, Wide (16:9), Zoom, True, Custom, Custom adj.,
Digital zoom +, Digital zoom -, Keystone, Ceiling, Rear and Reset] (pp.35-37).
For Video source, used to set size of image [Normal, Full, Wide (16:9), Zoom, Custom, Custom adj., Keystone, Ceiling,
Rear and Reset] (pp.44-45).
Input
Used to select an input source from Computer 1, Computer 2, Video or S-video. (pp.27-28,38-39).
Sound
Used to adjust the volume or mute the sound or set configurations to the MIC functions (p.24).
Information
Display the input source information: Input, H-sync freq., V-sync freq., Screen, Language, Lamp status, Lamp counter,
Power management, Security, Remote control, SERIAL NO. and Total power savings (p.59).
Guide
The key operation is displayed.
Setting
Used to set the projector’s operating configurations (pp.46-58).
Network
See owner’s manual of “Network Set-up and Operation”.
Basic Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
