Sanyo PLC-XU4000 - Input Source Selection (Computer 2: RGB)

28
Choose Computer 2(RGB) by pressing the INPUT button on the top control or press the COMPUTER 2 button
on the remote control.
Input Source Selection (Computer 2: RGB)
 Note:
 •When the Input Search function is set to On1 or On2,
the input signal will be searched automatically (p.47).
 •COMPUTER 2 can not be selected when using
the COMPUTER IN 2/ MONITOR OUT terminal as
MONITOR OUT output.
COMPUTER 2 button
Top Control
Remote Control
1
2
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Computer 2 and
then press the SELECT button.
Input Menu
Computer 2(RGB)
3
When Computer 2 is selected, analog RGB input
source will be selected directly.
INPUT button
Computer Input
Video
Computer 2(RGB)
S-video
Computer 1(RGB) /
(Component) / (Scart)
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals