59
Input Source Information Display
The Information Menu is used for checking the status of the image signal being projected and the operation of the projector.
H-sync freq.
V-sync freq.
Lamp counter
Information Menu
The horizontal frequency of the input signal is displayed in
KHz, or - - - - KHz when no signal.
The vertical frequency of the input signal is displayed in Hz,
or - - - - Hz when no signal. Numbers of Hz doubles when
during Interlace.
The cumulative lamp operating time is displayed.
Press the INFO. button on the remote control to display the
Information Menu.
INFO. button
Remote Control
Press the Point ▲▼ buttons to select the Information. The
Information Menu is displayed.
See below for displayed information.
Power management
Screen
Off, Ready, Shut down or Timer is displayed.
The selected screen size is displayed.
Input
Lamp status
The selected input source is displayed.
The selected lamp mode is displayed.
Information
Language
The selected language is displayed.
Key lock
The selected Key lock icon is displayed.
PIN code lock
Off or On 1 or On 2 is displayed.
Remote control
The selected remote code is displayed.
SERIAL NO.
The serial number of the projector is displayed. The serial
number is used to service the projector.
Total power savings
The saved amount of power and the exhausted CO2 are
displayed.
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
