Sanyo PLC-XU4000 - Computer Input; Input Source Selection (Computer 1: RGB )

27
Choose Computer 1(RGB) or Computer 1(Scart) by pressing the INPUT button on the top control or press the
COMPUTER 1 button on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB )
Computer Input
COMPUTER 1 button
 Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.47).
Computer
1
Top Control
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Computer 1 and
then press the Point ► button.
Use the Point ▲▼ buttons to select RGB and then
press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Video
Computer 2(RGB)
S-video
INPUT button
Computer 1(RGB) /
(Component) / (Scart)
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals