26
black out → the captured image →normal →
•••••
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When the projected
image is captured and is set as User in the Logo selection
(p. 48), the screen changes each time you press the NO
SHOW button as follows.
NO SHOW button
Press the P-TIMER button on the remote control to operate
the Count up/Count down function. See page 52 for details
of Setting for the P-timer function.
To stop the countdown, press the P-TIMER button. To cancel
the P-Timer function, press and hold the P-TIMER button for
a few seconds.
P-TIMER button
Press the IMAGE button on the remote control to select a
desired image mode of the screen. See pages 33, 41 for
details.
IMAGE button
No show disappears after 4 seconds.
P-Timer display
Note:
See the previous page for the description of
other buttons.
IMAGE button
NO SHOW button
P-TIMER button
SCREEN button
Select the screen size (See pages 35-37, 44-45 for details).
SCREEN button
Basic Operation
P-timer
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
