38
Choose Video or S-video by pressing the INPUT button on
the top control, or the VIDEO button or the S-VIDEO button
on the remote control.
Before using INPUT button, correct input source should be
selected through menu operation as described below.
1
2
Input Menu
Input Source Selection (Video, S-video)
Video Input
When video input signal is connected to the
VIDEO jack, select Video.
Video
When video input signal is connected to the
S-VIDEO jack, select S-video.
S-video
Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.47).
Top Control
INPUT button
Remote Control
VIDEO button
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ►or the SELECT button.
Use the Point ▲▼ buttons to select either Video or
S-video and then press the SELECT button.
S-VIDEO button
Video
S-video
Video
Computer 2(RGB)
S-video
Computer 1(RGB) /
(Component) / (RGB(Scart))
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
