52
Standby mode
This function is available when operating the projector via
network.
Eco ............ Select Eco when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Refer to the owner’s manual of “Network Set-up and
Operation”.
Note:
•FactorydefaultisNetwork.
•
When selecting Network, the cooling fans may be
running
depending on the temperature inside the projector even if
the projector is turned off.
Setting
X: disabled O: enabled
*1 When Eco is selected, it is only possible to
turn on the projector while using the
RS-232C serial port.
*2 When switch the Standby MIC out function
On and in Standby mode status, only MIC
volume can be output.
Monitor Out
Audio Out
Direct on
Serial command
Network
*1
*2
This function allows you to change the setting of the
P-timer and execute it.
Select one of the following options:
Count up ... The P-timer display 000:00 appears on
the screen and the count starts
(000:00–180:00)
Count down
.. The time set in the Timer setting appears
on the screen and the countdown starts.
Timer ......... Use the Point ▲▼ buttons to set the
Timer (1–180 Min). Timer is available in
Count down only. Factory default velue is
10 Min.
Start .......... It executes the count up or count down
function. Press the SELECT button at
Start and the indication changes into
Stop. To stop Count up or Count down,
press the SELECT button at Stop on
the screen menu, then the indication
changes into Restart. Press the SELECT
button at Restart to resume Count up or
Count down.
Reset ......... Reset the P-timer values.
Press the SELECT button at Reset to
return to the following value;
Count up ... "000:00"
Count down ... Timer that you set
Exit ............ To exit the P-timer operation.
P-timer
P-timer
P-timer display
Stop or Cancel the P-timer via Remote Control
To stop the P-timer function, press the P-TIMER
button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
