Sanyo PLV-Z3000 Owner's Manual

38
HDMI 1 setup/ HDMI 2 setup
Select Normal or Enhanced according to the output signal of video
equipment. Press the Point
8 or OK buttons to switch between
each option.
Normal . . . . When the output of video equipment is set to
“STANDARD.”
Enhanced . . When the output of video equipment is set to
“ENHANCED.”
The names for the output setting of video equipment vary from
equipment to equipment. For details, refer to the owner’s manual
of video equipment.
Background
Select the background screen for when no input signal is detected.
Press the Point
8 or OK buttons to switch between each option.
Blue . . . . Project a blue background
Logo . . . . Project an image selected in the Logo setting.
Black. . . . Project a black background
HDMI 1 setup
Press the Point 8 or OK
buttons to select Normal
or Enhanced according to
the output signal of video
equipment.
Background
✔Note:
 •WhentheLogosetting(seepage40)issetto“Off”withthe
“Logo”background,theBackgroundsettingwillbeswitchedto
“Blue.”
Setting
When using the projector in high altitudes (about 1,200 meters or
more above the sea level), set this function “On.” Press the Point
8 or OK buttons to switch On/Off.
Highland
✔Note:
 •Failuretosetthismodeproperlymayaffecttheprojectorlife.

Sanyo PLV-Z3000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	40 - 300 \
Aspect ratio	16:9
RS-232 ports	1
Dimensions (WxDxH)	400 x 146 x 346 mm
Lamp type	UHP
Lamp power	165 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Focus	Manual
Focal length range	22.3 - 45.3 mm
Noise level	19 dB
Dot clock scanning frequency	100 MHz
Serial interface type	RS-232
Component video (YPbPr/YCbCr) in	3

Weight and Dimensions

Weight	7500 g