Sanyo PLV-Z3000 Owner's Manual

40
Power off confirmation
When this function is set to “On,” a confirmation dialog box with
“Power off?” is displayed when turning off the projector (p.19).
Press the Point
8 or OK buttons to switch On/Off.
Capture
This function enables you to capture an image being projected to
use it for the starting-up display or interval of presentations.
Select Capture and press the Point
8 or OK buttons. The
confirmation box appears and select [Yes] to capture the projected
image. The captured image will be displayed the next time the
projector is turned on.
To cancel the Capture function, select [No].
Capture
✔Note:
 •AsignalfromacomputercanbecaptureduptoXGA(1024x768).
 •TheimagethathasbeenadjustedintheImageadj.Menuwillnot
bereflectedevenifitiscaptured.
 •IftheCapturefunctionfailstocaptureanimageorstopscapturing
halfway,theOn-ScreenMenureturnstotheCaptureitem.
 •TheCapturefunctioncannotbeoperatedwithunsupported
signals.
 •Whenstartingtocaptureanewimage,thepreviouslystored
imageisclearedevenifyoucancelthecapturing.
Select [Yes] to
stop capturing.
Select [Yes] to capture
the projected image.
Logo
This function decides on the starting-up display from among the
following options. Press the Point
8 or OK buttons to switch
between each option.
User . . . . . Show the Image you captured.
Default . . . Show the factory-set logo.
Off . . . . . . Show the Countdown display only.
Display
This function decides whether to display the On-Screen displays.
Press the Point
8 or OK buttons to switch between each option.
On . . . . . . . . . . . Show all the On-Screen displays. Use this
function when you want to project images
after the lamp becomes bright enough. The
factory default setting is in this option.
Countdown Off. . Show the input image instead of the
countdown when turning on the projector.
Use this function when you want to project
the image as early as possible even when the
lamp is not bright enough.
Off . . . . . . . . . . . Hide the On-Screen Displays except;
● On-Screen Menu
● “Power off?”
● “No signal” for Power management (p.41)
● “Please wait ...”
● Color management operation screen (p.32)
✔Note:
 •“User”optioncannotbeselectedwithoutcapturinganimage.
Setting

Sanyo PLV-Z3000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	40 - 300 \
Aspect ratio	16:9
RS-232 ports	1
Dimensions (WxDxH)	400 x 146 x 346 mm
Lamp type	UHP
Lamp power	165 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Focus	Manual
Focal length range	22.3 - 45.3 mm
Noise level	19 dB
Dot clock scanning frequency	100 MHz
Serial interface type	RS-232
Component video (YPbPr/YCbCr) in	3

Weight and Dimensions

Weight	7500 g