Sanyo SPW-CR703GDCH8 - Page 103

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 45
2. Optional Controller (system controller)
(1) Zone registration by remote controller (RCS-SH80TG)
❏ In this case confirming the indoor unit connected with the remote controller, you set the central address one by
one.
❏ In case of remote controller–less system, connect remote controller to the system temporarily then follow this
procedure.
a Press the TEST / CHK button at the bottom right on the remote controller for more than 4 seconds.
b Once in this mode, the UNIT No., CODE No., SET DATA and
SETTING
will flash on the display as shown below.
c Set the CODE No. 03 with
, (SET TEMP) button.
The CODE No.03 must be selected to perform the zone registration by the remote controller.
NOTE
Indoor unit address must have been already set before performing the zone registration.
If necessary you can refer to the installation manual attached in the outdoor unit.
NOTE
NOTE In case of group control, “ALL” instead of
UNIT No. will flush on the display. Select the
main indoor unit address by pressing the
UNIT button once.
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
800_8132
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
831_8132
830_8132
R.C. No.
SET
UNIT No.
No.CODE
DATA
SETTING