Control of W-ECO MULTI SYSTEM
3
TD831077
III - 46
d Set the central address which you want to set to this indoor unit address with , ( ) button according to
the zone registration table
2. Optional Controller (system controller)
For example, in case of left
Indoor unit address : 1–8
Central address : 17 (ZONE 2, GROUP 1)
e Press the SET button. The CODE No. and Central address changes from flashing to ON state. If you make
mistake, then press the CL button and re-set the central address.
f Press the TEST / CHK button to finish zone registration.
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
832_8132
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
833_8132
To Next Page
Loading...
