Sapido BRF71n - Wireless Security

http://www.sapido.com.tw/ User Manual v1.0.0
70
frame. After receiving an RTS, the wireless station responds with a
Clear to Send (CTS) frame to acknowledge the right to begin
transmission. Fill the range from 0 to 2347 into this blank.
Beacon Interval Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. The allowed
setting range is 20-1024 ms..
Preamble Type PLCP is Physical layer convergence protocol and PPDU is PLCP
protocol data unit during transmission, the PSDU shall be appended
to a PLCP preamble and header to create the PPDU. It has 2
options: Long Preamble and Short Preamble.
IAPP Inter-Access Point Protocol is a recommendation that describes an
optional extension to IEEE 802.11 that provides wireless
access-point communications among multivendor systems.
Protection Please select to enable wireless protection or not.
Aggregation Enable this function will combine several packets to one and transmit
it. It can reduce the problem when mass packets are transmitting.
Short GI Users can get better wireless transmission efficiency when they
enable this function.
WLAN Partition
Shut down the communication between the connected
wireless LAN devices.
If you set up as "Enabled", devices connected with the
router, such as a printer, will not be able to use.
Default Setting: "Disabled"
20/40MHz Coexist
Configure 20/40MHz coexisting scheme.
If you set up as "Enabled", "20MHz" and "40MHz" will
coexist.
Normally use as "Disabled".
Default Setting: "Disabled"
RF Output Power Users can adjust RF output power to get the best wireless network
environment. Users can choose from 100%, 70%, 50%, 35%, and
15%.
5.4.3 Security
Here users define the security type and level of the wireless network. Selecting different
methods provides different levels of security. Please note that using any encryption
may cause a significant degradation of data throughput on the wireless link. There
are five Encryption types supported: “None”, “WEP”, “WPA”, ”WPA2”, and “WPA-Mixed”.
Enabling WEP can protect your data from eavesdroppers. If you do not need this feature,
select “None” to skip the following setting