64
o = Factory setting
x = User-defined setting
Input of the Setup Application parameters
service password Fn key function
Device parameters (“Device parameters” menu structure depicted below)
Info
Language
Factory settings: all parameters
Setup Device WP1 Off
(Device parameters)
Enter the service RS-232
1
) SBI Standard
password for access
SBI Verifiable
o IS-232 (see “WP1 - Internal” menu
2
). Rather than A/D converter configuration,
the variant is selected here (“Variant”).
ADC-232 (see “WP1 - Internal” menu
2
)).
Internal A/D converter (see “WP1 - Internal - A/D converter configuration” on the page after next).
configuration
Calibration/ CAL key function o Ext. cal./adjust.; factory-defined weight
Adjustment Ext. cal./adjust.; user-defined weight
Ext. lineariz.; factory-def. wt.
2
)
Ext. lineariz.; user-defined weight
Set preload
Clear preload
Cal key blocked
Cal./adj. sequence Cal. then auto adjust
o Cal. then manual adjust
isoCAL function o Off
Adjustment prompt
Activate ext. o Activated
adjustment
3)
Deactivated
Parameter for Cal./adj. weight
external weight Linearization weight 1
Linearization weight 2
Linearization weight 3
Linearization weight 4
Adjust without Input parameters Nominal load
weights Resolution
Sensitivity for load cell 1
or mean value
for all load cells
Sensitivity for load cell 2
Sensitivity for load cell 3
Sensitivity for load cell 4
Save parameters
Geographical data Input parameters Geographical latitude
Elevation
Gravitational acceleration
Save parameters
For menu items “Adapt Filter” through “Factory settings see “Operating Menu
for weighing parameters”: Overview (Parameters)”
in “Configuring the Combics”
Device parameters “COM1” through “Terminal data”: see next page
1
) function will be made available in future
2
) availability of menu items depends on the software and on the functionality of the connected weighing platform
3
) menu item not available on scales verified for use in legal metrology
Overview of the Setup Menu in Service Mode