Sartorius MA150 - Page 33

Step Key (or instruction) Display/Printout
Weighing system is being prepared
for calibration
The following is displayed when the system
is ready for calibration
10. Place the 100 g calibration weight Position the 100 g
on the weighing system (here 100.00 g) calibration weight
“–” sign: weight too low
“+” sign: weight too high
No +/- sign: weight ok
At the end of calibration the display shows
11. If no adjustment is required,
select
END in the Function line y
and confirm u --------------------
14.07.2006 15:10
Model MA150Q-000230V
Ser. no. 18701636
Vers. no. 01-50-01
ID
--------------------
External calibration
W-ID
Nom. + 100.000 g
Diff. - 0.002 g
--------------------
14.07.2006 15:12
Name:
--------------------
12. If necessary, adjust the weighing system u
At the end of adjustment, the display shows
and a report is printed: (see next page)
33
100000
PROGRAMM
WGH.SYS CAL./ADJ.Verzög. 2sec
D
g
TARASETUP
100000
PROGRAMM
WGH.SYS CAL./ADJ.Verzög. 2sec
D
g
TARASETUP
0002
END
WGH.SYS CAL./ADJ.Verzög. 2sec
D
g
ADJUSTSETUP
0002
ENDE
WGH.SYS CAL./ADJ.Verzög. 2sec
D
g
JUST.SETUP
100000
CAL.
WGH.SYS CAL./ADJ.Verzög. 2sec
S
g
TAREEND