Error Codes in the Applications
Your Sartorius Counting Scale comes equipped with an automatic function-
monitoring feature. In case of function errors, error codes are shown in the main
display and output to the port until the error is corrected.
Display format: Err YXX
Data output format with header (menu setting 7 2 2): Stat ERR YXX
One type of error generates the same error code in all application programs.
Operating and Routine Errors
Your scale recognizes operating errors. Codes indicating operating errors are
shown for 2 seconds in the main display.
Error code: Error:
Err 01: Display overflow
Err 02: Zero point error when adjustment/calibration routine
was started (unload the scale)
Err 03: Zero point error when adjustment/calibration routine ended
or time has run out (internal)
Err 10: =/z key blocked when o/t key is active
Err 11: o/t key pressed with non-permissible value,
e.g. negative value
Err 12: o/t key pressed when the value was not within the
permitted range (overflow, range limits)
Err 22: Error when starting the counting function (weight <10 digits)
Err 23: Error when starting an application
Err 30: p/p key pressed with BPI mode active (internal)
Err 50: Temperature sensor switch defective (internal)
Err 53: Temperature sensor switch not functioning (internal)
Err 54: Balance load below minimum limit
Err 55: Balance load above maximum limit
Err 64: Numeric entry not permitted
Err 70: Wrong numeric entry format
Note:
Other error codes:
Switch the scale OFF and then back ON using the e/o key. If the error code
is still displayed, please contact our Service Unit.
3–36
To Next Page
Loading...
Need help?
General