Important Note:
Changes to the code settings are not stored if you
turn off the scale by pressing e/o while selecting
the code numbers or before saving a setting.
The current menu setting in the scale operating menu
is identified by a small, superscript “o” after the last
number. When you access the operating menu,
the previously set code will be displayed after you
have selected the right-hand number, which means the
entire menu code setting is displayed. This makes it
easy for you to check the previously set codes.
If you want to change several menu code settings,
you do not have to press =/z (14) after each
change to exit the scale operating menu. You can
also confirm individual settings.
Undoing All Menu Code Changes – Reset Function
The reset function lets you undo all menu code
changes, which means you will obtain the original
factory-set menu codes identified here by an “*”.
To use this function, select code 9 – – 1°.
For information on confirming and storing menu code
settings see the previous page.
2–3
To Next Page
Loading...
Need help?
General