Connecting Electronic Peripheral Devices
Make absolutely sure to unplug the scale from the
power supply before you connect or disconnect
a peripheral device (e.g. printer, PC, etc.) to or from
the interface port.
Adjusting the Display Unit
Adjust the display unit to the position desired.
If you use the QC scale in a Zone 2/Class I, Div. 2
hazardous area/location, the QC equipment must
be completely disconnected from AC power before
you connect or disconnect any cables to or from
the equipment. The same applies to all accessories
operated with the system.
1–27
To Next Page
Loading...
Need help?
General