Changing the Reference Sample Quantity “nRef”
You can change the reference sample quantity in cycles by pressing g/W key.
Use the number keys 0–9 and the u/w key to enter piece counts.
Choose from the following settings for the reference sample quantity: 5,10, 20,
50,100 and a user-definable number (factory setting: 999).
To change the ref. sample aty: press the g/W key (13) repeatedly and
select the desired reference sample quantity, or
enter directly using the numeric keys 0–9.
After the reference sample quantity “100 pieces,” 999 (or another number) is
displayed. You can overwrite this number directly using the numeric keys 0 –9
(saved in non-volatile memory).
Note: This setting is not canceled by the reset code 9 – – 1°!
If the scale is not loaded with the corresponding number of pieces, the “Err 22”
error code is displayed.
Make sure you enter the number for “reference sample quantity ‘nRef’” without
the decimal point (. key)!
A number entered manually without a decimal point is always a piece count!
You can exit this application at any time by pressing c/c + u/w
or g/W, and proceed with a new counting task.
Input of Reference Weight “wRef”
If you know the weight of a part, you can enter it directly as the reference weight
“wRef” using the numeric keys 0–9.
Make sure you enter the number with the decimal point (. key)!
A number entered manually with a decimal point is always a weight value!
You can enter a number of up to 7 digits manually.
Display reference weight for 2 seconds when
the counting function is started by pressing u/w Code Changes
Blocked 3 9 1 *
Display 3 9 2
* = factory setting
3–5
To Next Page
Loading...
