Net-total Formulation Application R
76
Preparation
§ Switch on the scale: Press the e key
§ While all segments are lit, press the
) key
§ Select the Setup menu: Press the
k key repeatedly until appl is
displayed
§ Confirm appl: Press the ) key
§ Selecting the Net-total Formulation
Application:
Press the k key repeatedly and
confirm with the ) key
Net-total Formulation Application
Parameters
3.6. Minimum load for autosave
3.6.1* 1 digit
3.6.2 2 digits
3.6.3 5 digits
3.6.4 10 digits
3.6.5 20 digits
3.6.6 50 digits
3.6.7 100 digits
3.6.8 200 digits
3.6.9 500 digits
3.6.10 1000 digits
3.17. Individual/Component printout
when saved
3.17.1 Automatic printing off
3.17.2* Print the entire standard
print configuration
every time with the O
key
3.17.3 Print the entire standard
print configuration
once with the O key
* = Factory setting
§ Save the settings with the ) key and
exit Setup: Press the ( key several
times.
Minimum load
The minimum amount that a
component must weigh before it can be
saved in net-total memory is configured
in Setup under:
Appl: R
: 3.6.
Signum
®
3:
appl 3
Net Tot: 3.6.
Once the limit is exceeded by the load,
the value can be saved. If the load on
platform is too light, the following will
occur when you try to save a value:
– The error code Inf 29 is displayed
– The weight is not saved
The minimum load required for
automatic taring of the container
weight on the platform (first weight)
is configured in Setup under:
Appl: R: 3.5.
Signum
®
3:
Appl: m.weigh: 3.5.
You can choose from the following
10 levels for this setting:
1 digit
2 digits
5 digits
10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
The “digits” here refer to the scale
intervals in the connected weighing
platform. If the interval of the
connected platform is 1 g, for example,
and 1000 digits are required, you must
place at least 1000 g (= 1000 intervals
=1000 digits) on the weighing platform
for initialization.
Net-total Formulation
with Two Weighing Platforms
This mode is used for weighing large
and small components at the same
time.
It is possible to toggle from the small-
component platform to the large-
component platform once during a
measurement series. Once you toggle
to the large-component platform, the
( and ) keys are available until
a component is saved. For example,
you can tare a partially-filled container
taken from the small-component
platform on the large component
platform.
The value in component memory
on the small-component platform is
transferred to the large-component
platform and the weight unit is
converted, if necessary. The Component
and Additive display modes are both
available on the large-component
platform.
The value read by the active platform
is saved in component memory.
The displayed result is accurately
calculated in the active weight unit.
When you press c to stop a
measurement series the tare memories
for both platforms are cleared, unless
the large-component platform is an SBI
instrument, in which case the platform
is only tared.
To Next Page
Loading...
