Satake Scan Master II - Page 4

490128-90EMB
6/08J
TABLE OF CONTENTS
ScanMasterII SMII 800, SMII 810, SMII 820, AND SMII 830 IRF/IEF
PARAGRAPH PAGE
© 2008, Satake USA Inc. INDEX - PAGE 3 OF 6
(ALL RIGHTS RESERVED)
SECTION 2 - IDENTIFICATION AND FUNCTION OF PARTS (CONTINUE)
2.5.1 SETUP1 SCREEN 2-12
2.5.1.1 Lamp Level 2-12
2.5.1.2 Spot Size 2-12
2.5.1.3 Background Position 2-14
2.5.1.4 Ejector Timing 2-14
2.5.1.4.1 Delay Adjustment 2-14
2.5.1.4.2 Dwell Adjustment 2-15
2.5.1.5 Lamp Fault Bypass 2-15
2.5.2 SETUP2 SCREEN 2-15
2.5.2.1 Trip Mode 2-15
2.5.2.2 Sort Mode 2-15
2.5.2.3 Lamp Type 2-17
2.5.2.4 View Mode 2-17
2.5.2.5 Wiper Timing 2-17
2.5.2.6 Feeder Control 2-18
2.5.3 SETUP3 SCREEN 2-18
2.6 BACKGROUND ADJUSTMENT SCREEN 2-18
2.7 STATUS SCREEN 2-19
2.7.1 Feeder Run-Time Summary 2-19
2.7.2 Viewer Temperatures 2-25
2.7.3 Status Indicators 2-25
2.8 FRAME GRAB SCREEN 2-26
2.9 EJECTOR RATE NORMALIZATION SCREEN 2-26
2.10 MAINTENANCE1 SCREEN 2-29
2.11 MAINTENANCE2 SCREEN 2-29
2.12 PRINTED CIRCUIT CARD CAGE 2-32
2.13 TIMING PCB 2-32
2.13.1 Indicators 2-32
2.13.2 Test Points 2-32
2.14 AMPLIFIER PCB 2-32
2.15 AMPLIFIER INTERFACE PCB 2-37
2.16 EJECTOR INTERFACE PCB 2-39
2.16.1 Ejector Testing 2-39
2.16.2 Reset LED 2-39
2.16.3 Computer 2-39
2.16.4 Status 2-41
2.17 EJECTOR CONTROL PCB 2-41
2.18 EJECTOR DRIVER PCB 2-41
2.19 BACKGROUND CONTROL I/O PCB 2-41
2.20 MONITOR CONTROL PCB 2-44
2.21 CPU INTERFACE MODULE 2-44
2.22 FEEDER DRIVER PCB 2-47
2.23 EJECTOR CONNECTOR PCB 2-47
2.24 SYSTEM INTERFACE PCB 2-47
2.24.1 Remote Computer Connections 2-47
2.24.2 PLC Connections 2-51
2.24.2.1 Connecting the 4-20 Milliamp Control 2-51
2.24.2.2 Testing the Remote Feeder Control 2-52
2.24.2.3 Lamp Monitor PCB 2-52