490128-90EMB
6/08J
TABLE OF CONTENTS
ScanMasterII SMII 800, SMII 810, SMII 820, AND SMII 830 IRF/IEF
PARAGRAPH PAGE
© 2008, Satake USA Inc. INDEX - PAGE 4 OF 6
(ALL RIGHTS RESERVED)
SECTION 3 - OPERATION AND ADJUSTMENTS
3.0 SCOPE 3-1
3.1 PRE-OPERATIONAL CHECKS 3-1
3.1.1 Air Pressure 3-1
3.1.2 Switch Positions 3-1
3.1.2.1 Amplifier PCB 3-1
3.1.2.2 Ejector Interface PCB 3-2
3.1.3 Testing the Air Ejectors 3-2
3.2 OPERATING THE ScanMasterII 3-2
3.2.1 Normal Startup 3-2
3.2.2 Normal Shutdown 3-3
3.2.3 Power Failure 3-3
3.2.3.1 Restoring Power 3-3
3.2.3.2 Restoring Power After a Minimal
Power Failure 3-3
3.2.4 Adjusting the Background(s) 3-4
3.2.5 Adjusting the Gain of the Amplifiers 3-4
3.2.6 Adjusting Ejector Dwell Time 3-6
3.2.7 Adjusting Ejector Delay 3-6
3.2.8 Adjusting the Feed Rate 3-6
3.2.9 Adjusting the Dark Trip Control 3-7
3.2.10 Adjusting the Light Trip Control 3-7
3.2.11 Adjusting the Size Control 3-8
3.3 EVALUATION OF SORTING RESULTS 3-8
SECTION 4 - MAINTENANCE
4.0 SCOPE 4-1
4.1 CHECKING AND CLEANING THE FEEDER TRAY 4-1
4.2 CHECKING AND CLEANING THE CHUTES 4-2
4.3 CHECKING THE WINDOW WIPER 4-2
4.4 CHECKING AND CLEANING THE VIEWER 4-2
4.5 LAMP REPLACEMENT 4-2
4.6 ADJUSTING THE LAMP BALLASTS 4-3
4.7 CLEANING THE AIR EJECTORS 4-5
4.8 SERVICING THE COMPRESSED AIR FILTER SYSTEM 4-7
4.8.1 Servicing the Pre-Filter 4-8
4.8.2 Servicing the Oil Removal Filter 4-8
4.9 CLEANING THE TOUCH SCREEN DISPLAY 4-11
SECTION 5 - TROUBLESHOOTING
5.0 SCOPE 5-1
5.1 POSSIBLE PROBLEMS AND PROBABLE CAUSES 5-1
To Next Page
Loading...