Section 2: Installation
Page 2-12 CG4 Series Operator Manual
2.5 CONNECTIONS (cont’d)
2.5.4 Connecting the Power Cable
1.
Connect the AC power cable to the AC adapter.
2. Connect the DC power plug from the AC adapter to the
DC input power terminal on the back of the printer.
Make sure the flat side of the DC power plug is facing
right. Secure the printer with one hand, and insert the
cable firmly.
3. Insert the AC power plug into a AC power outlet.
Make sure that the AC voltage of your region is within
the range of AC 100 to 240V, 50/60 Hz.
A 3-pin plug is attached to the power cord provided with
your printer. One of these pins is the ground wire.
You must use a 3-pin power outlet. The plug will not
work with a 2-pin power outlet.
* The shape of the power plug may vary depending on
the location where the printer was purchased.
Warning
• Be sure to connect the ground wire. Failure to do so may cause an electric shock.
• Do not operate the power switch or insert/remove the power cable while your hands are wet.
Doing so may cause an electric shock.
Caution
The power cable and the AC adapter provided with this printer are for use with this printer only.
They cannot be used with other electrical devices.
Flat side faces right.
DC input power
terminal
To Next Page
Loading...
Need help?
General
