SATO CG408 User Manual

Section 3: Operation and Configuration
CG4 Series Operator Manual Page 3-7
3.3 USER TEST PRINT MODE (cont’d)
USB and IEEE 1284 interface on board
USB and LAN interface on board
No. Print Item Contents of the print data
1 Selected Interface In-use interface USB / IEEE1284
2 Interface 1 Interface 1 USB
3 Buffer Type Buffer type Multi
4 Protocol Protocol Driver
5 Serial No. Serial No. Serial No./ None
6 Interface 2 Interface 2 IEEE1284
7 Buffer Type Buffer type Multi / 1 item
8 Protocol Protocol Driver
No. Print Item Contents of the print data
1 Selected Interface In-use interface USB / LAN
2 Interface 1 Interface 1 USB
3 Buffer Type Buffer type Multi
4 Protocol Protocol Driver
5 Serial No. Serial No. Serial No./ None
6 Interface 2 Interface 2 LAN
7 Buffer Type Buffer type Multi
8 Protocol Protocol Driver(CYC)
Driver(ENQ)
Status3
9 MAC Address MAC address **:**:**:**:**:**
10 IP Address IP address 000.000.000.000
~ 255.255.255.255
11 Subnet Mask Subnet mask 000.000.000.000
~ 255.255.255.255
12 Default Gateway Default gateway 000.000.000.000
~ 255.255.255.255
13 DHCP DHCP Enable / Disable
14 RARP RARP Enable / Disable

SATO CG408 Specifications

General

Resolution	203 dpi
Max Print Width	104 mm
Print Method	Thermal Transfer
Max Print Speed	4 inches/sec
Media Roll Diameter	127 mm (5 inches)
Memory	4 MB Flash
Interface	USB, Serial, Ethernet
Media Sensor	Reflective and Transmissive
Media Thickness	0.06 mm - 0.19 mm
Ribbon Length	100 m (328 ft)
Label Thickness Range	0.06 mm - 0.19 mm