11
setting of the “ rEACT ” parameter in the SET-UP environment, in other words, either after passing by
the net zero of the scale, by instability or always (see section “REENABLING OF THE PRINTOUTS
AND THE INDICATOR FUNCTIONS”).
If the presence of a printer has been configured, the "MODE" key or automaticly causes also the
printing of the weight values.
After a totalisation, press the MODE key again:
- with the normal totalizer, one can temporarily view on the display the number of weighs carried out and
the PARTIAL NET TOTAL accumulated until that moment (Subtotal): if the accumulated digit is more
than 6 digits the visualisation takes place in two stages.
- with the fast totalizer the " no.0.UnS " error message is displayed.
NOTE:
- If the gross or net weight is equal to zero, with the normal totalizer the indicator displays the
accumulated total, while with the fast totalisation the “GroS.Er or nEt.Err” error message is
displayed.
TOTALISATION WITH PRINTING
If the presence of a printer has been configured, upon each pressing of MODE, one prints the data
programmed in step SEtuP >> SEriAL >> CoM.Prn >> Pr.ConF of the set-up environment
(TECH.MAN.REF.), for example:
- Weigh number
- GROSS weight
- TARE weight
- NET weight
PRINTING AND ZEROING OF THE TOTALS
The instrument has two different total levels, a partial total and a general total, which increase upon
each totalisation; these may be printed and zeroed independently from each other.
To print and zero the PARTIAL TOTAL one should press for ashort time the ENTER key; depending on
the type of totalisation, various messages will be displayed:
- With normal totalisation the number of weighs and the accumulated total will be displayed.
- With fast or automatic totalisation the message “totAL” will be displayed.
The number of weighs made and the NET WEIGHT TOTAL is printed.
To print and zero the GENERAL TOTAL
one should press for a few seconds the ENTER key;
depending on the type of totalisation; various messages will be displayed:
- With normal totalisation the number of weighs and the accumulated total will be displayed.
- With fast or automatic totalisation the message “G.totAL” will be displayed.
The number of weighs made and the NET WEIGHT TOTAL is printed.
NOTE:
All the values accumulated are automatically zeroed each time the instrument is turned off.
17.6 VERTICAL TOTALIZER (Sum by recipe -> tot S)
Like the horizontal totaliser but with each pressing of MODE (or automatcly depend of parameter
rEACT) the indicated weight is totalised and automatically tared; in this way it is possible for example to
fill a container with various products and to know the total weight of the container (on the display or/and
on a printer) and the total weight of all the containers weighted (on the display or/and on a printer) .
17.7 PIECE COUNTING (COUn)
In this functioning mode it is possible to carry out the reference operations in order to use the scale for
counting pieces.
When the functioning mode is selected (F Mode -> FunCt -> Coun) , one is asked to set some
parameters:
To Next Page
Loading...
