Scaime ipe 50 - Minimum Weight of the Sample; Printing under Counting Mode; Diplay and Modification of Average Piece Weight (APW)

13
MINIMUM WEIGHT OF THE SAMPLE
It is advisable to use a reference quantity equal or greater than 0,1% of the scale capacity.
In any case, the weight of the reference quantity should not create an APW lower than the two internal
points of the converter (intrinsic limit of the instrument); if this condition takes place, during the sampling,
the display will indicate for an instant: "Error " and the quantity put on the plate will not be accepted.
One should therefore use a higher reference quantity.
PRINTING UNDER COUNTING MODE
If the presence of a printer has been configured, each time ENTER is pressed, while either weight or
pieces are displayed, one prints the data programmed in the SEtuP >> SEriAL >> CoM.Prn >> Pr.ConF
of the set-up environment; for example:
- GROSS weight
- TARE weight
- NET weight
- Quantity of PIECES (PCS) on the scale in that moment.
- calculated APW, expressed in the set unit of measure, with three decimal digits
Nota:
Setpoint in counting mode
Select in Setup : outPut for the relays : 3 PCS and these others parameters
To change the setpoint value:
Press the key ENTER at least 3 seconds, the display shows : inP.PMu, press the key : ->T<- to obtain
inP.StP, press the key ENTER, the display shows : S.1 on and press ENTER to see the value and to
change it if necessary with keys MODE,->0<- , ->T<- and ENTER (at this end use key C to return in
counting mode).
Diplay and modification of average piece weight (APW)
It is possible to see and modify this value.
Press ENTER at least 3 seconds, the display shows : inP.Pmu, press ENTER again, and the bAPW is
shown.
You could modify it, if necessary with keys MODE,->0<- and ->T<-.
Attention : the value can't be displayed completely in first place, to see the whole value, use the key
MODE.