26
1) Enter the SET-UP environment of the scale (when turned on, press for an instant the ZERO or
TARE key during the countdown).
2) Select the SEtuP → Com.Prn → PrMode step and press ENTER
3) Select the desired printer (“tPR” or “LP542P) and press ENTER
4) In the “SET-UP ENVIRONMENT” section see the descriptions of the “baud.Pr”, “Bit.Pr”,
“PWr.Prn”, “on.Prin” and “Prn.CtS” steps for configuring the baud rate, the number of
transmission bits, the printer’s power supply and the CTS signal.
5) Select the “Pr Conf” step and press ENTER/PRINT: one enters the PROGRAMMING MENU
OF THE PRINTOUTS. Below is the description of the steps.
6) Once the setting have been made, press the C key various times until the indicator shows
“SAVE? In the display: confirm with ENTERto memorize and return to weighing.
PrConF CONFIGURATION OF THE PRINTOUTS
In this step one enters the print programming submenu.
NOTE: the parameter and all its submenus are not displayed unless the “Prno”
parameter has been selected in the “PWr.Prn” step or “Pr- no” in the “PrModE” step.
LanG PRINTING LANGUAGE
One selects the language in which the printouts are carried out:
ItAL italian.
EnGL english.
dEut german.
FrAn french.
ESPA spanish.
bLinE EMPTY LINE AT THE BEGINNING OF THE PRINTOUT
YES at the beginning of each printout an empty line is inserted.
no no empty line.
(!) YES
IntES PRINTING OF HEADING
Not available
(!) Int no
nuMWEi PRINTING OF NUMBER OF WEIGHS (ONLY FOR TOTALIZER MODE)
no does not print the number of weighs.
tot prints the number of weighs only in the single totalisation.
Sum prints the number of weighs only in the partial total.
both prints the number of weighs in the totalisations as well as in the partial total.
NOTE: the parameter is displayed only if the “totalizer” functioning mode has been
selected.
(!) both
dOM PRINTS DATE AND TIME
dt. no the date and time are not printed.
dt.in.1 the date and time are printed using the clock inside the printer; in the totalizer
functioning mode the date and time are printed just in the total and not in the
single totalizations
dt.in.2 as above, but in the totalizer functioning mode the date and time are printed
also in the single totalizations.
dt.EX.1 like “dt.in.1” but the indicator’s date and time board (optional) is used.
To Next Page
Loading...
