Scaime ipe 50 - Screen Saver and Printing

4
16.4 “SCREEN SAVER” FUNCTION (OPTIONAL)
If the indicator is fitted with the date/time function, it is possible to enable the “Screen Saver”: after a
programmable time (from 1 to 255 minutes) with the scale unloaded, the time is shown on the display, in
the “HH-MM-SS” format. As soon as a weight variation is detected, or a key is pressed, the indicator
returns to viewing the current weight.
To set the function:
- Select menu F.Mode.
- Press ENTER to enter the menu.
- Press ->0<- many times (to scroll forwards through the parameters) or ->T<- (to scroll backwards) to
find the “SCr.SAV” parameter.
- Press ENTER to enter the parameter.
- With the ->0<- or ->T<- key select the possible options: “no” (disabled), “YES” (enabled).
- Confirm with ENTER if one has selected “YES”, one is asked to enter the number of minutes after
which the indicator should show the time: enter a number between 1 and 255 (using the MODE key
to select the digit to be modified and the ZERO/TARE keys to decrease/increase it) and confirm with
ENTER
- Press the C key many times until the display shows the message “SAVE?”.
- Press ENTER to confirm the changes made or another key to not save.
NOTE: the “SCr.SAV” parameter is not shown if there is no date/time option.
16.5 PRINTING
If a printer is connected, it is possible to print the programmed weight data, for example:
- GROSS weight
- TARE weight
- NET weight
- ticket number
- date and time (optional)
- a CODE 39 bar code (both with the LP542PLUS labeller as well as the TP200 thermal printer).
Besides the generic printing described above, each single functioning mode will have some specific
printouts, which are described in the operating mode.
Executing printouts with NON approved scales.
In order to print with non approved scales the following conditions must exist:
- the weight must be stable;
- the gross weight must be >= of a division;
To configure the printouts, go to the “PROGRAMMING THE PRINTOUTS”
16.6 REENABLING THE PRINTOUTS AND THE INDICATOR FUNCTIONS
While using the indicator, it is possible to incur into the “no.0.unS” error shown on the display along
with an acoustic signal; this means that the printing or the function which one wants to carry out must be
reenabled (in order to avoid unwanted executions).
It is possible to set the reenabling in different ways: “passage by zero of the net weight”, “weigh
instability” or “always”. Follow the procedure below:
- Select menu F.Mode.
- Press ENTER to enter the menu.
- Press ->0<- many times (to scroll forwards through the parameters) or ->T<- (to scroll backwards)
until one finds the “rEACt” parameter.
- Press ENTER to enter the parameter.
- With the ->0<- or ->T<- keys select the possible options: “ZEro” (passage by zero of the net
weight), “inSt” (instability), ALWAyS.
- Confirm with ENTER
- Press the C key many times until the message “SAVE?” is shown on the display.
- Press ENTER to confirm the changes made or another key to not save.