20
Manual tare command
[CC]TMANVVVVVV<CR LF> or [CC]WVVVVVV<CR LF> (short command).
VVVVVV : value of the tare with comma from 1 to 6 digits
Instrument response: [CC]OK<CR LF> if the command has been RECEIVED; the instrument’s response
does not mean necessarily that the instrument executes the tare.
Zero command
[CC]ZERO<CR LF> or [CC]Z<CR LF> (short command)
Instrument response: [CC]OK<CR LF> if the command has been RECEIVED; the instrument’s response
does not mean necessarily that the instrument executes the zero.
ESC or C command
[CC]C<CR LF>
Instrument response: [CC]OK<CR LF> if the command has been RECEIVED; the instrument’s response
does not mean necessarily that the instrument executes the command.
The command works also within the SET-UP environment.
Channel selection (in IND.CH mode)
[CC]CGCHN<CR LF>
Instrument response: [CC]OK<CR LF>
N: the number of the channel selected (channel that will be displayed on the IPE)
Test Command
[CC]ECHO<CR LF>
Instrument response: [CC]ECHO<CR LF>.
Setpoint command (if the option is installed)
[CC]STPTntxxxxxxtyyyyyy<CR LF>
in which: n indicates the SETPOINT number (1 to 6 depending of the model)
t F if the following weight value indicates the DISABLING of the relays (OFF).
t O if the following weight value indicates the ENABLING of the relays (ON). xxxxxx and yyyyyy take on
the setpoint value of disabling or enabling: the digits must be entered WITHOUT the decimal point,
omitting the NON significant zeros.
Instrument responses:[CC]OK<CR LF> in case of syntax and correct values.
[CC]NO<CR LF> in case of correct syntax but wrong values.
Note: if the setpoint is programmed without hysteresis, the value xxxxxx must be equal to yyyyyy.
Example of instrument with capacity 10,000 kg and division 1 g:
Command: STPT1F5000O6500 (Disabling relay 1 at 5 kg and enabling at 6,5 kg)
Response: OK
NOTE: An error response of the instrument happens in the following cases:
- one of the two entered values is greater than the capacity.
- one of the two entered values has a minimum division that is inconsistent in comparison to the one
set in the instrument.
- the disabling value is greater than that of enabling.
- The command is wrong
NOTE: The values are available until the unit is not switched off, to record its into a non volatile memory
(EEPROM) you must send the command :
[CC]CMDSAVE<CR LF>.
Instrument response: [CC]OK<CR LF>
To Next Page
Loading...
