28
DEFAuL PRINTOUT DEFAULT
Through this StEP one enables the default printing relative to the selected functioning
mode.
The default sets, in each of the following steps, the value marked with the (!) symbol.
FiLdS PRINTING FIELDS
Through this StEP it is possible to select which fields to be printed among those
available:
G; n; t; G n; G t; n G; n t; t G, t n; G n t; G t n; n G t; n t G; t G n, t n G (in which G is the
gross weight; n is the net weight and t is the tare weight).
(!) G t n
hEiGt FONT HEIGHT SELECTION FOR PRINTING THE WEIGHT DATA, DATE AND
TIME, PROGRESSIVE NUMBERS AND ID’S:
ChAr 1 normal height
ChAr 2 double height
(!) ChAr 1
bArC PRINTS THE BAR CODE
In this step one programmes the printing of the 39 CODE (if “TPR” has been selected in
the “PrModE” step), which will be printed before the printing of the date and time:
no does not print the bar code.
yes.tot prints the bar code; in the totalizer functioning mode it is printed just in the
single totalisations.
SuM prints the bar code; in the totalizer functioning mode it is printed just in the
partial total.
both prints the bar code; in the totalizer functionig mode it is printed in the
totalizations as well as in the partial total.
(!) no
NOTES:
- the weight values are expressed in 6 digits without decimal point and with the possible
non significant zeros present.
- between a weight value and the following one a space is inserted.
- the bar code is printed as the last data, after the weight values, possible numeric
codes and ticket number, but before the date and time (with TP200 printer).
THE FOLLOWING PARAMETERS ARE VISIBLE ONLY IF IN THE PREVIOUS STEP A PARAMETER
DIFFERENT FROM "no" HAS BEEN SET.
VdbAr SELECTING THE BAR CODE’S VERTICAL DISTANCE OF THE PRECEDING TEXTS:
In lines with normal height font, programmable value: 0…9. (!) 0
TPr (for TP200 printer)
To Next Page
Loading...
