Scania DI13 series User Manual

OPM 250 en-GB 41
©
Scania CV AB 2016, Sweden
Cooling system
Cleaning the charge air cooler
The charge air cooler must be removed if there is
no space behind it to take out the cooler core. See
previous section.
1. Remove the cover (1) of the charge air cool-
er.
2. Press in the cooler core (3) slightly on one
side and pull it out from the other side.
3. Clean the cooler core on the outside with par-
affin-based engine detergent. Remove any
internal deposits using a round rod. Renew
the cooler core if it is damaged.
IMPORTANT!
Do not use caustic soda as this could damage the
aluminium.
4. Renew damaged or hard O-rings (2).
5. Assemble the charge air cooler. Tighten the
M8 screws on the covers to 15 Nm.
2
5
2
4
2
3
2
1
1
362 798
1. Cover.
2. O-rings.
3. Cooler core.
4. Charge air cooler housing.
5. Spacer.

Scania DI13 series Specifications

General

Cooling System	Liquid-cooled
Displacement	12.7 liters
Aspiration	Turbocharged
Aftertreatment	SCR (Selective Catalytic Reduction)
Engine Type	Inline 6-cylinder
Fuel System	Common rail direct injection