Schaerer Coffee Vito

BA SCV_EN
V05 | 04.2013
17
www.schaerer.comInstallation and commissioning
Power requirements
Changeover between mains water supply and drinking water tank
(Option)
Changeover from mains water supply to drinking water tank and vice versa is possible with the
optional facility "Aquaflex" (e.g. for the purpose of decalcification).
Option 1: Changeover from mains water supply to drinking water tank.
► Close the main water valve on the water supply line and, if necessary, detach the hose.
► Remove the right-hand front cover.
► Turn the rotary switch anticlockwise with the multi-tool.
 The arrow on the rotary switch now points to the tank symbol.
► Fill and insert the drinking water tank.
Option 2: Changeover from drinking water tank to mains water supply
► Remove and empty the drinking water tank.
► Turn the rotary switch clockwise with the multi-tool.
 The "arrow" on the rotary switch now points to the water tap symbol.
► Attach the right-hand front cover.
► Fit the hose for the water supply to the machine and water supply line.
► Open the main water valve on the water supply line.
Installation
Unpacking the machine
► Unpack the machine.
► Check the remaining package contents for accessories.
► Remove the accessories supplied in the grounds container and water tank.
► Keep the original packaging in case the equipment needs to be sent back.
Installing the mains water supply (Option)
► Insert the seals carefully (attached to the hose).
► It is imperative that you check the connections for seal tightness.
► Attach the hose to the connector on the back of the machine and to the on-site angle valve
(3/8").
► Open the main water valve.
Water pressure
Recommended: 0.1–0.6MPa (1–6bar)
Maximum: 0.6 MPa (6 bar)
Water inlet temperature
Minimum: 10°C
Maximum: 35°C
The adjusting screw is located be-
hind the drinking water tank.
Read the “Setting up the coffee machine” and “Power supply” chapters carefully before install-
ing.