Schaerer Coffee Vito - Installing a waste water outlet; Connecting the milk

www.schaerer.com Installation and commissioning
BA SCV_EN
V05 | 04.2013
18
Installing a waste water outlet
Option 1: Inserting a drip tray without an opening
► Insert the drip tray.
Option 2: Drip tray with opening
► Insert the drip tray.
► Fit the waste water connection (see below)
Option 3: Waste water connection
► Push the hose with the elbow onto the end of the hose on the rear side of the machine.
► Connect the discharge hose to the waste water system.
► Make sure that the hose does not sag (shorten it if necessary!).
Connecting the milk
► Push the beverage outlet to its highest position.
► Press the release on the rear side of the beverage outlet and pull the foamer head down-
wards.
► Conduct the milk hose through the opening (arrow) and fit it onto the foamer head (see il-
lustration).
► From below insert the foamer head upwards again into the beverage outlet guide until it
engages.
Option 1: External cooling units
► Conduct the milk hose through the bottom openings (see illustration). If the beverage outlet
is misadjusted, make sure that the milk hose is not kinked.
► Select the desired milk nozzle (included in the scope of supply) and insert it at the end of
the hose that is located on the outside.
 The milk connection is ready for external milk cooling units.
With the option "Aquaflex" a selection can be made from the above mentioned options.