BA SCV_EN
V05 | 04.2013
57
www.schaerer.comService and maintenance
3. 3-fold system rinsing
► Rinse the drinking water tank with water, fill it and reinsert it.
► Empty the collecting container and drip tray and place them back under the outlets.
► Continue the decalcification process by pressing the field "Continue".
Rinsing starts and is then repeated with 2 further identical rinsing procedures.
► Empty and replace the collecting container and drip tray after the 3rd system rinse.
► Fill and insert the drinking water tank.
► Continue the decalcification process by pressing the field [Continue].
4. Making ready for operation.
► Execute the optional display request for machines with an internal water filter. See option
"With water filter".
► Continue the decalcification process by pressing the field "Continue".
There is a danger of scalding in the dispensing area.
The machine heats up automatically, so do not reach under the dispensing areas.
► Confirm the display message "Caution, the machine is heating up!" by pressing the field
"Continue".
The machine heats up automatically.
The display message "Decalcification completed correctly" appears.
► Confirm the display message by pressing the field [Continue].
The machine heats up and starts "warm rinsing".
The machine blows off steam out of the steam outlet.
► Switch over again, if the machine has an optional mains water supply. See below "Option:
with mains water supply"
The decalcification process is completed and the machine is ready for operation.
Option 1: With water filter
If an optional internal water filter is being used in the drinking water tank, the display request
"Remove calcium filter from tank" appears after the cooling down routine".
► Remove the water filter (optional) from the drinking water tank before the decalcifier is
poured in.
► Then continue the decalcification process by pressing the button "Continue".
► Follow the ensuing display requests, see decalcification process.
► Reinsert the water filter at the end of the decalcification process.
Option 2: With mains water supply
If a mains water supply connection is available, the display request "Change Aquaflex" ap-
pears after starting the decalcification process.
► Close the main water valve of the mains water supply.
► Remove the right-hand front cover.
► Change over from mains water supply to "drinking water tank".
Prompt occurs only with an internal
water filter (optional)
Prompt occurs only with an internal
water filter (optional)
See "Service and maintenance" - "Water filter (optional)" - "Changing the water filter for the
internal drinking water tank".
Display message, if with "mains wa-
ter supply" (optional)
See "Installation and commissioning" - "Changeover from mains water supply to drinking water
tank"
To Next Page
Loading...
