www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
17
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
and success.
Note:
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
•
technicians,
• Installation and replacement of non-original spare
parts,
•
•
due to the non-compliance of the electric regula-
tions and local regulations.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
-
service life of the machine.
-
-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
-
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
operating manual and the particular instructions for
-
ulations for the operation of identical devices must
be complied with.
arise due to non-observance of these instructions
2. Device description (Fig. 1 - 14)
1. Transport handle
2. Pressure switch
3. Quick-lock coupling (regulated compressed air)
4. Pressure gauge (for reading the preset vessel
pressure)
5. Pressure regulator
6. Pressure gauge (for reading the vessel pres-
sure)
7. Quick-lock coupling (unregulated compressed
air)
8. Pressure vessel
9. Supporting foot (2x)
10. Drain plug for condensation water
11. Wheel (2x)
12. Oil drain plug/ Oil– level window
13. Compressor pump
14.
15. Oil sealing plug
16. ON/OFF switch
17.
18. Overload switch
19.
20. Screw (Wheel)
21. Washer (Wheel)
22. Spring washer (Wheel)
23. Nut (Wheel)
24. Screw (Supporting foot)
25. Washer (Supporting foot)
26. Nut (Supporting foot)
27. Distance sleeve
3. Scope of delivery
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, lm and small parts! There is a risk of
swallowing and suocation!
•
• 2x Supporting foot
• 2x Wheel
• 1x Mounting material
• 1x Oil sealing plug
• 1x Oil bottle
• 1x Translation of original operating manual
• Open the packaging and remove the device care-
• Remove the packaging material as well as the
packaging and transport bracing (if available).
•
To Next Page
Loading...
Need help?
General
