www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
18
|
GB
• -
port damage.
•
period has expired.
4. Intended use
The compressor is designed to generate com-
pressed air for compressed-air driven tools which
can be driven with an air volume of up to approx. 294
gun).
well ventilated indoor space.
misuse. The user / operator and not the manufactur-
caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
-
ment is used in commercial, trade or industrial busi-
nesses or for equivalent purposes.
5. Safety information
m Attention!
must be observed when using electric tools for pro-
-
-
erence.
Safe work
1.
- Disorder in the work area can lead to accidents.
2.
- Do not expose electric tools to rain.
- Do not use electric tools in a damp or wet envi-
ronment. There is a risk of electric shock!
- Make sure that the work area is well-illuminated.
- Do not use electric tools where there is a risk of
3.
-
pipes, radiators, electric ranges, cooling units).
4.
- Do not allow other persons to touch the equip-
area.
5.
-
elevated or closed location out of the reach of
children.
6.
-
output range.
7. Wear suitable clothing
-
become entangled in moving parts.
- Rubber gloves and non-slip shoes are recom-
mended when working outdoors.
- Tie long hair back in a hair net.
8. Do not use the cable for purposes for which it is
not intended
- Do not use the cable to pull the plug out of the
outlet. Protect the cable from heat, oil and sharp
edges.
9.
-
- Follow the maintenance instructions.
- Check the connection cable of the electric tool
specialist when damaged.
-
them when damaged.
10. Pull the plug out of the outlet
- During non-use of the electric tool or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
11. Avoid inadvertent starting
-
plugging the plug into an outlet.
12. Use extension cables for outdoors
-
extension cables for use outdoors.
-
13. Remain attentive
- -
sible when working. Do not use the electric tool
14. Check the electric tool for potential damage
- Protective devices and other parts must be care-
and function as intended prior to continued use
of the electric tool.
- Check whether the moving parts function fault-
-
aged.
- -
-
eration of the electric tool.
- Damaged protective devices and parts must be
-
- Damaged switches must be replaced at a cus-
tomer service workshop.
-
cables.
To Next Page
Loading...
