www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
19
-
15.
electrician
- This electric tool conforms to the applicable safe-
an electrician using original spare parts. Other-
wise accidents can occur.
16. Important!
- -
sories and additional units listed in the operating
manufacturer. The use of mounted tools or ac-
cessories other than those recommended in the
17. Noise
-
18. Replacing the power cable
- To prevent hazards, leave the replacement of
-
electric shock!
19.
-
with a suitable pressure gauge, for example at
20. -
tions
-
for the maximum permissible operating pressure
of the compressor.
21. Place of installation
- Set up the compressor on an even surface.
22.
23.
24. Use a residual current circuit breaker with a trig-
ger current of 30 mA or less. Using a residual cur-
rent circuit breaker reduces the risk of an electric
shock.
m WARNING! This electric tool generates an elec-
-
pair active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
manufacturer of the medical implant prior to operat-
ing the electric tool.
ADDITIONAL SAFETY INSTRUCTIONS
Observe the corresponding operating manuals
of the respective compressed air tools / com-
pressed air attachments! The following general
warnings must also be observed.
Safety instructions for working with compressed
air and blasting guns
•
at least 2.50 m, and keep the compressed air tools
-
pressor during operation.
• The compressor pump and lines can become
•
explosions in the compressor pump.
• When releasing the hose coupling, hold the hose
-
ing hose.
• -
ing with the compressed air pistol. Dusts are harm-
-
• Do not blow at people with the blow-out pistol and
do not clean clothes while being worn. Risk of in-
Safety instructions when using spraying attach-
ments (e.g. paint sprayers)
• -
contact with the compressor.
•
•
point below 55 °C. Risk of explosion!
• Do not heat up paints or solvents. Risk of explo-
sion!
• If hazardous liquids are processed, wear protective
liquids.
• The details and designations of the Ordinance on
outer packaging of the processed material, must be
observed. Additional protective measures are to be
suitable clothing and masks.
•
in the work area. Risk of explosion! Paint vapours
• Never set up or operate the equipment in the vicin-
• Do not store or eat food and drink in the work area.
•
To Next Page
Loading...
Need help?
General
